SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
#1
|
|||
|
|||
soon to be back in a SVX again
Looks like I am probably going to end up back into a SVX again.
This time it will be a 97. will update soon. Anyone selling a factory 97 front grill, and a hood? thanks, going to need those things for starts.
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K |
#2
|
||||
|
||||
Re: soon to be back in a SVX again
Grills can be had from Subaru (not cheap) but very seldom from fellow SVXers or ebay and maybe listed on ebay for an Alcyone.
|
#3
|
||||
|
||||
Re: soon to be back in a SVX again
got my grill for about $100 a couple years ago from subaru
__________________
Seth 94' Barcelona Red w/ Tricoat black 2-tone AWD Ls -Sold Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats Soon to come:Fiberglass hood, upholster ALL suede to black leather Past subies: 92' Pearl White/black top LS-L-SOLD 96' Legacy Outback-TOTALED 99' Legacy Outback Limited 30th anniversary edition-TOTALED 98' Forester L -Totaled Other toys: 99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap 06' B9 Tribeca-Stock 1982' Yamaha xj650 Maxim Mods: work in progress |
#4
|
|||
|
|||
Re: soon to be back in a SVX again
'97 grille is $160.00 from Subaru.
|
#5
|
|||
|
|||
Re: soon to be back in a SVX again
yeah unless the grille is tucked away in the trunk, and if it is busted up and there I still am going to need one.
polo green would be terrific. also going to need a hood, and keep my fingers crossed on anything else. 97 LSi polo #290...... anyone interested in buying a polo green scoop ?
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K |
#6
|
|||
|
|||
Re: soon to be back in a SVX again
I am looking to have someone provide me some measurements for a SVX that has never been wrecked in the front.
This is the picture from auction on the one I have on the way. It was smacked dab center, high, above the bumper but into the upper radiator support. When I redid my CR-Z with similar hit, I just went to the dealer with a tape measure and pad pad of paper at drew out the schematics/distance measured from the upper shock tower bolts, and some of the fender bolts, to the front radiator core support, brackets to hold the radiator in place, left and right, criss cross, etc. I can't simply go to the dealer, or anyone around here to compare. someone that has some free time, and wants to earn my brownie points, give me some measurements......thanks I realize, that once I get a good hood, i can fit it to the latch, but I want to be as close to factory measurements, and I do this with a come along, some metal brackets/metal bars, and lots of patience. My BRAT or a tree usually serves as anchor point for the come along, that way the vehicle I pull is in one spot, I can just maneuver that BRAT around for different pull angles.....
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K Last edited by bheinen74; 09-30-2014 at 06:04 PM. |
#7
|
|||
|
|||
Re: soon to be back in a SVX again
I realize, that once I get a good hood, i can fit it to the latch, but I want to be as close to factory measurements, and I do this with a come along, some metal brackets/metal bars, and lots of patience. My BRAT or a tree usually serves as anchor point for the come along, that way the vehicle I pull is in one spot, I can just maneuver that BRAT around for different pull angles.....
Been there and done that when my daughter hit a boat trailer with my '92. Got it fixed up with a new hood and then hit a deer on the way to the hospital when my wife broke her knee cap (not with a baseball bat) 6 months later. Did it again. |
#8
|
||||
|
||||
Re: soon to be back in a SVX again
I would love to help with measurements but, not sure where to start. Blacky, what a bad luck story.
__________________
Gene and Ben 1992 SVX LS AWD 110K - Liquid Silver 1994 SVX LSi AWD 128K - White Pearl (daily driver) 1994 SVX LSi AWD 95K - Emerald Pearl (sold) 1992 SVX LS-L AWD 115K - Dark Teal 4.44 swap (sold) |
#9
|
|||
|
|||
Re: soon to be back in a SVX again
Check the manual: http://www.phantomotaku.com/SVX/MSA5...d_exterior.pdf
From page 48 on the body datum points are explained in detail and the required dimensions are given. I think all you need is there, the small 5mm hole you see on the front valance (radiator support) is one of the datum points. If you need any other specific measurements just let us know - you have our support ! Good luck, Tapani |
#10
|
|||
|
|||
Re: soon to be back in a SVX again
Thank you much Tapani. That link is what I need.
fig 84, shows the points. looking at 41.26 inches from major datum to the center core..........I will be able to make use of that diagram... even though the pic looks like too me it's not that severe, in the past, my experience it is always worse off than you plan it to be, always plan for much more damage than you can hope for......so more cost to repair. Hopefully the car will get here by next week...... It's been about 4 years since I have been on here with a SVX. Wasn't there someone local to me in WI that had a bunch of SVX parts and always parting? Guess, I will hope some of the yards around here that back in the day had some, still have parts......maybe this rebuild will be more challenging than I am ready for. My 04 Outback that was hit in front, was a sway/side hit and it pushed everything one way, whereas this one looks direct center, which I am hopeful that is the case...alot easier to deal with. My first SVX was a 92 ls-l, which I wish I would have researched a little more before I got it. I did research enough to find one with a replaced trans, bearings, etc. But, it had its share of issues (security module wouldn't learn a new fob, air bag light would be lit unless it was a warm day, and the replaced trans had a strange thing, among other things) So, I will hopefully be a little bit more happy with a 97 lsi, and maybe won't have a huge ton of money in it to be fearful of it getting a few scratches, door dings, etc when it is left in a parking lot.
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K Last edited by bheinen74; 09-30-2014 at 07:59 PM. |
#11
|
|||
|
|||
Re: soon to be back in a SVX again
|
#12
|
|||
|
|||
Re: soon to be back in a SVX again
car got here today.
Grille was behind the front seat. overall decent. Motor was smooth and quiet but has exhaust leak up front somewhere..... washed it, removed the seat covers, checked oil and atf etc. got my work ahead........
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K |
#13
|
||||
|
||||
Re: soon to be back in a SVX again
Let's see it!
__________________
When I was in school I sucked in sports. Then I found out I can buy trophies and now I am great at everything. |
#14
|
|||
|
|||
Re: soon to be back in a SVX again
heres a grille teaser
quick shot before it got unloaded.
__________________
1985 Brat GL 138k 91 CRX Si 40k 91 CRX Si 155k 97 SVX Lsi 70k 2003 s2000 91 RT4WD 166K Last edited by bheinen74; 10-09-2014 at 07:05 PM. |
#15
|
|||
|
|||
Re: soon to be back in a SVX again
I'll take the car underneath it!
|
|
|