Live Chat!
SVX or Subaru Links
Old Lockers
Photo Post
How-To Documents
Message Archive
SVX Shop Search
|
SVX Network Forums Live Chat! SVX or Subaru Links Old Lockers Photo Post How-To Documents Message Archive SVX Shop Search |
IRC users: |
|
#1
05-02-2009, 07:43 AM
|
||||
|
||||
|
Fender Liner
I've been getting a rubbing sound from the drivers front on hard cornering. Upon inspection I've discovered that the inner liner has a pucker in it. There is a molded bump toward the top front that fits over a metal seam. This is where the liner has puckered and it is bulged by a couple of inches. You can see where the tire is rubbing it and beginning to wear through it.
I tried pushing it up but it just pops back. Is there a trick to re positioning the liner? My worry is that crud, salt etc. will get behind it and rust out the area. Last edited by SVX_MY_BABY; 05-02-2009 at 01:32 PM. 
|
|
#2
05-02-2009, 10:38 AM
|
||||
|
||||
|
Re: Fender Liner
The liner is supposed to go behind the rubber moulding around the fender lip.
__________________
Seth 94' Barcelona Red w/ Tricoat black 2-tone AWD Ls -Sold Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats Soon to come:Fiberglass hood, upholster ALL suede to black leather Past subies: 92' Pearl White/black top LS-L-SOLD 96' Legacy Outback-TOTALED 99' Legacy Outback Limited 30th anniversary edition-TOTALED 98' Forester L -Totaled Other toys: 99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap 06' B9 Tribeca-Stock 1982' Yamaha xj650 Maxim Mods: work in progress
|
|
#3
05-02-2009, 01:30 PM
|
||||
|
||||
|
Re: Fender Liner
It is behind the molding. It's the side closest to the engine that has this V shaped bulge similar to a folded tent card. It runs about 5 inches.
|
|
#4
05-02-2009, 03:31 PM
|
||||
|
||||
|
Re: Fender Liner
I would remove the thing and see exactly what the story is.
Applying a heat gun should allow you to get it shaped back good enough and hold in that position till it cools it should stay there. Just a thought... Keith 
|
 |
|
|
Linear Mode
